Parameter Settings At Power Turn-On - AMERITECH AM5 Instruction Manual

AM5(e) Classic Instruction Manual
4.3.2 Parameter Settings at Power Turn-on: Many of the functions have parameters
that may be changed for a specific test setup. More detail on the settings of
parameters and measurements are described in Sections 6 and 9 that describe
MEASURE and SEND, respectively. A brief summary follows (Value Range
column shows the minimum <default> and maximum values for parameters):
Function key
MEASURE
Use up and down
arrow keys to
step through
measurements.
Use PARAM SEL
key to step
through
parameters.
SEND
SEND
SEND
SEND
November 19, 1997
(18-0047)
Function LED
IMP N
W/T
(Impulse Noise
with tone)
or
IMP
NOISE (without
tone)
*Note: Time,
impulse counters ,
and noise are
measurements
listed in order of
display as up arrow
key is pressed).
QUIET
NOTE: Any LEVL
setting affects all
SEND levels.
All Frequency
ranges are 0.020
through 120.0
kHz (or 200.0
kHz). See Value
Range column
defaults
1004 Hz
VAR Hz
SWEEP
Page 4-2
SELF TEST and CALIBRATION
Meas*/Parameter
TiME
iHi (High,
iMid Middle,
iLo Low
Impulse
Counters)
noiS (Noise)
dur (duration)
iTHd (Impulse
Threshold)
idLT (Impulse
Delta)
bLnc (Blanking
Interval)
LEVL (all SEND
Levels)
F1
F2
F3
F4
VERsion (typical)
LEVL
FrEQuency
LEVL
FrEQuency
LEVL
STrT Frequency
SToP Frequency
STEP Size
rATE
dLAY (delay)
Value Range
0.0 MINutes
0 CNT
0 CNT
0 CNT
(Above data
depend on last test)
uNdr
000.1 <015.0>
999.9 MINutes
20.0 <68.0> 110.0
dBrn
(AM5) or
–70 <–-22> +20
dBm (AM5e)
2, 3, <4>, 6 dB
0001 <0125> 0255
mSEC
-50.0 <00.0> 13.0
dBm
AM5 [AM5e]
0.404 [0.304] kHz
1.004 [1.004] kHz
2.804 [2.004] kHz
2.713 [3.004] kHz
101A
(all SEND)
1.004 kHz
(all SEND)
1.004 kHz
(all SEND)
0.304 kHz
3.004 kHz
0.100 kHz
000.1 <003.0>
999.9 SEConds
<000.0> 999.9
SEC