AM5(e) Classic Instruction Manual
3.6 ACCESSORIES
This sub-section describes the accessories for the AM5(e) Classic . These items are not
automatically supplied with the AM5(e) Classic . They must be added to the order by
customer request; however, they can be added in the field if desired.
3.6.1 Line Cables: Three types of Line Cables may be ordered for a front-panel line
connection to the bantam jacks (TX/2W and RX). The cables are six-feet in length
and differ in the terminations to the equipment. Cables are as follows (two must be
ordered for four-wire operation):
• 48-0047
• 48-0048
• 48-0062
Refer to Section 5, Line Connections, for illustrations.
3.6.2 Protective front panel (85-0078): This is a plastic cover which is designed to fit
over the front panel of the AM5(e) Classic . It clips to the slots on either side of the
front panel bezel and protects the front panel from damage.
Note : This cover is not needed if the Model 30-0033XT Signaling Adapter option is ordered.
3.6.3 Padded Carrying Case (87-0070): This case is intended to protect and carry the
AM5(e) Classic to field-testing locations. The AM5(e) Classic can be operated
without removing it from the case. The case is constructed of padded green/grey
heavy canvas and has pouches to hold Instruction Manual, Cables, small tools, and
other items.
3.6.4 19" Rack Mounting Kits (85-0076): This kit (usually ordered before shipment)
provides the brackets for permanent mounting of an AM5(e) Classic in a standard 19
inch rack. Mounting feet and carrying handle are not installed on the AM5(e) Case
when this item is ordered.
3.6.5 19" Rack Mounting Shelf (85-0233): This shelf is similar in purpose to the Rack
Mounting Kit. However, it is specifically designed to be used with an AM5e Classic
with the Siemens-type "banana" input adapter.
November 19, 1997
(18-0047)
Bantam (M) to Bantam (M) Input Cable
Bantam (M) to 310 (M) Input Cable
Bantam (M) to mini-clip Input Cable
(END OF SECTION 3)
Page 3-18
DESCRIPTION