Obtain Nw User Property - Kyocera ecosys M2735DW Operation Manual

User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration

Obtain NW User Property

Set the required information to obtain the network user property from the LDAP server. The user name obtained with this
setting is shown in the user information, the status confirmation screen, and the header of E-mail.
NOTE
To obtain the network user property from the LDAP server, [Network Authentication] must be selected for the
authentication method in "Enabling User Login Administration". Select "On" for "LDAP" in "Protocol Settings".
Enabling User Login Administration (page 9-3)
Protocol Settings (page 8-31)
The table below explains the required information to be registered.
Item
*1
Server Name
Port
*2
Name 1
*3
Name 2
*4
Authentic at Type
Search Timeout
*1 If using Active Directory of Windows, the server name may be the same as the server name entered in the network
authentication.
*2 If using Active Directory of Windows, displayName of Attribute may be used as "Name 1".
*3 "Name 2" can be left out. When you assign displayName in "Name 1" and department in "Name 2", and if the value of
displayName is "Mike Smith" and the value of department is "Sales" in Active Directory of Windows, the user name appears as
"Mike Smith Sales".
*4 Appears when the server type is set to "Kerberos" in "Network Authentication".
1
Enter the LDAP server name or the IP address (up to 64 characters). If a server name is not
entered, user information will be acquired from the server set for Network Authentication.
Port number for LDAP server. The default port number is 389.
Enter the LDAP Attribute to obtain the user name to be displayed from the LDAP server (up to
32 characters).
Enter the LDAP Attribute to obtain the user name to be displayed from the LDAP server (up to
32 characters).
Set the authentication method. Select [Simple] or [SASL]. After changing the setting, restart the
system or turn the power off and then on.
Set the amount of time to wait before time-out in seconds (from 5 to 255 seconds).
Display the screen.
1
[System Menu/Counter] key > [User Login/Job Accounting]
NOTE
If the user authentication screen appears, enter your login user name and login
password and select [Login]. For this, you need to login with administrator privileges.
The factory default login user name and login password are set as shown below.
Model Name
ECOSYS M2735dw
ECOSYS M2640idw
2
[User Login Setting] > [Obtain NW User Property] > [On]
Descriptions
Login User Name
3500
4000
9-21
Login Password
3500
4000