Spill Containment Overflow Warning Indicator - Shindaiwa DGK25F Owner's And Operator's Manual

(4) OVER SPEED (Engine Overspeed) Warning Indicator
This generator is equipped with a function such that the engine is automatically stopped if an
engine fault occurs causing the engine speed to increase excessively. If the engine speed
rose above 2,070rpm during operation, the OVER SPEED warning indicators and ENGINE
warning indicators illuminates, and the engine will be automatically stopped. If this occurs, it
is probable that some malfunction has occurred in the engine. Contact authorized distributor
where the generator was purchased.
(5) AIR FILTER (Air Cleaner Clogging) Warning Indicator
The AIR FILTER warning indicator illuminates if the air cleaner element becomes clogged
during operation. If it illuminates, immediately stop the engine and clean or replace the air
cleaner element.
(Refer to section "10. Inspection/Maintenance (3) Air Filter Element Cleaning/Replacement".)
(6) SPILL CONTAINMENT (Spill Containment Amount) Checking Indicator
The SPILL CONTAINMENT checking indicator illuminates if the liquid stored in the spill
containment exceeds approximately about 8gal ( 30.3 liters ) during operation. If it illuminates,
immediately stop the engine and flush the liquid stored in the spill containment.
(Refer to section "10. Inspection/Maintenance (9) Flushing Liquid in Spill Containment".)
< Note >
 The engine may not be stopped only if the spill containment checking Indicator illuminates during
operation.
 When the spill containment checking Indicator illuminates during operation, stop the engine,
check for fuel, oil and cooling water leakage, and repair as necessary.
 Do not use the equipment with liquid accumulated in the spill containment. Drain the spill
containment before using.
(7) ENGINE (Engine Malfunction) Warning Indicator
The ENGINE warning indicator illuminates if the coolant temperature is high, the oil pressure
is low, the engine overspeeds, the battery voltage is low or some other engine fault occurs
during operation. If this occurs, a malfunction code is displayed on the engine and available
output monitors, and the engine automatically stops or the engine output is reduced.
If the ENGINE warning indicator illuminates, contact the authorized distributor where the
generator was purchased.
5-5. SPILL CONTAINMENT (Spill Containment Amount) Overflow Warning
Indicator
WARNING : INJURY
 Do not open the check door during operation. Be careful of pinching or
catching of moving parts such as the cooling fan and fan belt.
 Always be sure to stop the engine and remove the starter key when
performing inspection or maintenance.
CAUTION : BURNS
 Do not touch the engine and surrounding components immediately after
stopping the engine as they are still extremely hot.
13