Shindaiwa DGK25F Owner's And Operator's Manual page 42

(6) Electromagnetic Fuel Pump Filter Cleaning/Replacement
Clean/Replace
Set a container to catch spilled fuel.
1
Turn the cover, located at the bottom of pump,
2
counter-clockwise and remove cover.
3
Remove the filter and gasket.
4 Clean the filter with the compressed air and
rinse it in the fuel before installing the filter and
gasket.
Reinstall in the reverse order.
5
< Note >
 After attaching, be sure to always start the engine
and check that there is no fuel leakage.
 Always be sure to wipe up any spilled fuel.
 After replacing the filter, always air out the fuel system.
(Refer to section "9-3. Procedures during Operation".)
 When a damage is found on the filter and gasket, replace with new parts.
 Filter kit ( Including Gasket kit ) part no .: 8980714010 (Isuzu part no.)
 Gasket kit ( Without Filter ) part no .: 8980714040 (Isuzu part no.)
(7) Draining Water from the Fuel Tank
Drain Water Every 250 hours
Set a container to catch spilled water.
1
Remove the fuel drain plug and packing (with rubber
2
seal).
After the water has been drained, reinsert the fuel
3
drain plug with new packing (with rubber seal).
< Note >
 Replace the packing of the fuel drain plug with new packing each time the water is drained.
 Packing part no.: V106-000110
 After reinserting the fuel drain plug, be sure to always check that there is no fuel leakage.
(8) Coolant Replacement
Replace
1
Set a container to catch spilled engine oil.
2
Remove the radiator plate.
3 Remove the radiator cap.
Remove the coolant drain plug.
4
Apply sealant coating to the plug or wrap it in seal
5
tape.
After the coolant has been drained, tighten the
6
coolant drain plug.
Every500 hours
Every 1,000 hours
39
Electromagnetic
Fuel Pump
Gasket
Filter
Gasket
Cover
Fuel Drain Plug
with Rubber Seal
Radiator Plate
Filler Neck
Radiator Cap