Table of Contents
Advertisement
5.5 Cylinder Head Gasket - Install
(1) Wipe off oil, grease and other contamination from the
cylinder head bottom surface and crankcase top sur-
face.
(2) Install the cylinder head gasket coated with liquid gas-
ket onto crankcase with dowel pin and hole in align-
ment.
5.6 Cylinder Head Assembly - Install
(1) Apply engine oil to the cylinder head bolt threads, bolt
seats and washer surfaces.
Note: Do not apply excessive amount of engine oil. Remove
the excess before assembling.
(2) Install the eye nut to stud bolt, and lift the cylinder head
assembly.
(3) Slowly lower the cylinder head, and place the cylinder
head properly by aligning the holes with the dowel
pins, and tentatively tighten the cylinder head bolts
except long ones.
Chapter 7 ASSEMBLY OF BASIC ENGINE
Dowel pin
Dowel pin
Dowel pin
Cylinder Head Gasket - Install
Eye nut
P/N:08014-00003
(M12 × 1.25 mm)
Cylinder Head Assembly - Install
Application of
engine oil
7-29
Advertisement
Table of Contents
