Governor Drive And Fuel Injection Pump Accessory Drive - Install; Fuel Injection Pump Gear - Install - Mitsubishi S12A2 Service Manual

Chapter 7 ASSEMBLY OF BASIC ENGINE

4.6 Governor Drive and Fuel Injection Pump Accessory Drive - Install

4.6.1 Fuel Injection Pump Accessory Drive - Install
(1) Install the O-ring to the mounting surface of the fuel
injection pump accessory drive case.Apply a thin coat
of ThreeBond 1212 to the flange.
(2) Install the fuel injection pump accessory drive to the
rear plate.
4.6.2 Governor Drive - Install (Oil Pressure Governor
Spec)
(1) Apply a thin coat of ThreeBond 1212 to the packing
mounting surface of the governor drive, and attach the
packing to the surface.
Apply a thin coat of ThreeBond 1212 on the packing.
(2) Install the governor drive to the rear plate.

4.7 Fuel injection pump gear - Install

(1) Align the match mark on the camshaft with the Wood-
ruff key on the drive shaft, and install the fuel injection
pump gear to the shaft.
(2) Tighten the nuts to the specified torque.
7-22
Accessory drive
Electronic
governor spec Governor drive Governor drive Governor drive
Oil pressure
governor spec
Governor Drive and Fuel Injection Pump and
Accessory Drive - Install
Align the mark 「3」 on the
camshaft gear with the mark 「3」 on
the fuel injection pump gear.
Camshaft gear
Woodruff key
Fuel injection pump gear - Install
Fuel injection pump gear
Nut
294 ± 15 N·m
{30 ± 1.5 kgf·m}
[217 ± 11.1 lbf·ft]