Flywheel Face And Radial Runout - Measure; Flywheel - Remove; Timing Gear Case - Remove - Mitsubishi S12A2 Service Manual

2.1 Flywheel Face and Radial Runout - Measure

Measure the face and radial runouts of the flywheel, and
know the current condition.
For the measurement procedure, refer to "Flywheel Face
and Radial Runout - Measure" of "ASSEMBLY OF BASIC
ENGINE."

2.2 Flywheel - Remove

(a) Be careful not to drop or bump the flywheel.It can,
not only cause damage to parts, but also lead to
personnel injury.
(b) Be careful not to cut your hands with the ring gear
when pulling-out the flywheel.
Be sure to remove the pickups before removing the
flywheel.
(1) Hitch a sling to the flywheel to prevent it from falling.
(2) Screw two jack bolts evenly into the jack bolt holes,
and remove the flywheel.

2.3 Timing Gear Case - Remove

Be careful not to drop or bump the timing gear case.It
can, not only cause damage to parts, but also lead to
personnel injury.
(1) Hitch a sling to the timing gear case to prevent it from
falling.
(2) Lift the timing gear case to disengage the dowel pins,
and remove the timing gear case.
(3) Remove the oil seal from the timing gear case.
Note: Do not reuse the removed oil seal.
Chapter 5 DISASSEMBLY OF BASIC ENGINE
Flywheel Face and Radial Runout - Measure
Jack bolt (M12 × 1.75 mm)
Flywheel - Remove
Oil seal
Timing Gear Case - Remove
Face runout
measuring plane
Radial runout
measuring plane
Sling
Flywheel
Eyebolt
P/N:05930-00200
(M12 × 1.25 mm )
Timing gear case
5-9