E-Cpos Interface Configuration Example 2 - HP HSR6800 Configuration Manual

[RouterB-E-Cpos2/0/0-oc-3-1] using oc-3c
[RouterB-E-Cpos2/0/0-oc-3-1] quit
[RouterB-E-Cpos2/0/0] oc-3 2
[RouterB-E-Cpos2/0/0-oc-3-2] using oc-3c
[RouterB-E-Cpos2/0/0-oc-3-2] quit
[RouterB-E-Cpos2/0/0] quit
# Configure channelized interface POS 2/0/0/1:0.
[RouterB] interface pos2/0/0/1:0
[RouterB-pos2/0/0/1:0] ip address 10.110.4.2 255.255.255.0
[RouterB-pos2/0/0/1:0] mtu 9200
[RouterB-pos2/0/0/1:0] quit
# Configure channelized interface POS 2/0/0/2:0.
[RouterB] interface pos2/0/0/2:0
[RouterB-pos2/0/0/2:0] ip address 10.110.6.1 255.255.255.0
[RouterB-pos2/0/0/2:0] mtu 9200
[RouterB-pos2/0/0/2:0] quit
3. Configure Router C:
# Create a 155-Mbps POS interface on E-CPOS 2/0/0.
<RouterC> system-view
[RouterC] controller e-cpos 2/0/0
[RouterC-E-Cpos2/0/0] using oc-3c
# Configure POS interface POS 2/0/0:0.
[RouterC] interface pos2/0/0:0
[RouterC-pos2/0/0:0] ip address 10.110.5.2 255.255.255.0
[RouterC-pos2/0/0:0] mtu 9200
4. Configure Router D:
# Create a 155-Mbps POS interface on E-CPOS 2/0/0.
<RouterD> system-view
[RouterD] controller e-cpos 2/0/0
[RouterD-E-Cpos2/0/0] using oc-3c
# Configure POS interface POS 2/0/0:0.
[RouterD] interface pos2/0/0:0
[RouterD-pos2/0/0:0] ip address 10.110.6.2 255.255.255.0
[RouterD-pos2/0/0:0] mtu 9200
Use the display interface pos 1/0:0 command to check the connectivity status and use the ping
command to check whether the network is reachable.

E-CPOS interface configuration example 2

Network requirements
Configure a 2.5 Gbps E-CPOS interface to carry traffic through 155 Mbps POS channels, as shown
in Figure 22.
80