Displaying And Maintaining Interface Backup; Interface Backup Configuration Examples; Multi-Interface Backup Configuration Example - HP MSR Series Configuration Manual

Step
2. Set the delay timer for the
backup function to take
effect on system startup.

Displaying and maintaining interface backup

Task
Display statistics about the traffic
on the active interfaces enabled
with load balancing.
Display the state information of the
active and standby interfaces.

Interface backup configuration examples

Multi-interface backup configuration example

Network requirements
Use interfaces Serial 2/1 and Serial 2/2 on Router A to back up the active interface Serial 2/0,
assigning interface Serial 2/1 a higher priority, and configure switchover delays.
Figure 7 Network diagram
Configuration procedure
1. Configure IP addresses:
Follow
shown.)
2. Configure a static route:
# On Router A, configure a static route to the segment 192.168.2.0/24 where Host B resides.
<RouterA> system-view
[RouterA] ip route-static 192.168.2.0 24 serial 2/0
Command
standby timer startup seconds
Figure 7 to configure the IP address and subnet mask for each interface. (Details not
Command
display standby flow [ | { begin | exclude
| include } regular-expression ]
display standby state [ | { begin | exclude
| include } regular-expression ]
17
Remarks
Optional.
30 seconds by default.
Remarks
Available in any view.
Available in any view.