Configuring An E-Cpos Interface - HP HSR6800 Configuration Manual

Figure 20 Network diagram for an E-CPOS application
In actual applications, the connection between these low-end routers and the E-POS interfaces might
span more than one transmission network and as such, might require relay. This is similar to the scenario
where low-end devices are connected to Router A through one or multiple E3/T3 leased lines.

Configuring an E-CPOS interface

Before transmitting data over SONET/SDH optical interfaces and using low-speed ports for accessing,
configure the E-CPOS interface first.
Complete the following tasks to configure an E-CPOS interface:
Configuring an E-CPOS interface
•
Configuring the operating mode of an E-CPOS interface/channel
•
Configuring an E-CPOS interface
Step
1. Enter system view.
2. Configure the working mode
of an interface card.
Command
system-view
card-mode slot slot-number.subslot
subslot-number e-cpos
74
Remarks
N/A
To make the newly
configured working
mode take effect, you
must restart the device
or hot swap the
interface board (if the
interface board
supports hot
swapping) after
working mode switch.
For more information about
configuring the working mode of
an interface card, see
Fundamentals Configuration
Guide.