HP HSR6800 Configuration Manual page 49

Step
9. Set the framing format.
10. Configure alarm signal
detection/sending.
11. Start a BERT test.
12. Configure FEAC channel
signal detection/sending on
the CT3 interface.
13. Configure MDL message
detection/sending on the CT3
interface.
14. Place a T1 line on the far-end
CT3 interface in a loopback.
15. Set the FDL format for a T1
channel.
16. Set the intended bandwidth
for the CT3 interface.
17. Restore the default settings for
the CT3 interface.
Command
•
On the CT3 interface:
frame-format { c-bit | m23 }
•
On a T1 line:
t1 line-number set
frame-format { esf | sf }
•
On the CT3 interface:
alarm { detect | generate { ais
| febe | idle | rai } }
•
On a T1 line:
t1 line-number alarm { detect |
generate { ais | rai } }
•
On the CT3 interface:
bert pattern { 2^7 | 2^1 1 |
2^15 | qrss } time number
[ unframed ]
•
On a T1 line:
t1 line-number bert pattern
{ 2^1 1 | 2^15 | 2^20 | 2^23
| qrss } time number
[ unframed ]
•
feac detect
•
feac generate loopback
{ ds3-line | ds3-payload }
•
feac generate { ds3-los |
ds3-ais | ds3-oof | ds3-idle |
ds3-eqptfail }
mdl { data { eic string | fic string |
| gen-no string | lic string | pfi
string | port-no string | unit
string } | detect | generate
{ idle-signal | path | test-signal } }
t1 line-number sendloopcode
{ fdl-ansi-line-up |
fdl-ansi-payload-up |
fdl-att-payload-up |
inband-line-up }
t1 line-number set fdl { ansi | att |
both | none }
bandwidth bandwidth-value
default
44
Remarks
Optional.
By default:
•
The framing format on the CT3
interface is C-bit.
•
The framing format on the T1
line is ESF.
Optional.
Alarm detection is enabled by
default.
Optional.
BERT test is disabled by default.
Optional.
FEAC channel signal detection is
enabled by default, but no FEAC
signals are sent.
Optional.
By default, MDL message detection
and sending are disabled and the
default MDL message information
applies.
Optional.
Optional.
By default, FDL is disabled.
This operation applies only to T1
channels that are formed on CT3
interfaces, operate in channelized
mode, and use ESF as the T1
framing format.
Optional.
Optional.