Configuring An E1-F Interface In Unframed Mode; Configuring Other E1-F Interface Parameters - HP HSR6800 Configuration Manual

Step
3. Configure the interface to
operate in framed mode.
4. Bundle timeslots on the
interface.
5. Enable RAI detection on the
interface.
6. Set other interface
parameters.

Configuring an E1-F interface in unframed mode

Step
1. Enter system view.
2. Enter E1-F interface view.
3. Configure the interface to
operate in unframed mode.
4. Set other interface
parameters.

Configuring other E1-F interface parameters

Step
1. Enter system view.
2. Enter E1-F interface view.
3. Configure the interface
description.
4. Set the line code format.
5. Set the clock mode.
6. Enable automatic clock mode
change.
7. Set the cable type.
Command
undo fe1 unframed
fe1 timeslot-list list
fe1 alarm detect rai
See "Configuring other E1-F
interface parameters."
Command
system-view
interface serial interface-number
fe1 unframed
See "Configuring other E1-F
interface parameters."
Command
system-view
interface serial serial-number
description text
fe1 code { ami | hdb3 }
fe1 clock { master | slave }
clock-change auto
fe1 cable { long | short }
33
Remarks
Optional.
The default is framed mode.
Optional.
If no timeslot range is specified, all
timeslots are bundled by default.
Optional.
Enabled by default.
Optional.
Remarks
N/A
N/A
The default is framed mode.
Optional.
Remarks
N/A
N/A
Optional.
By default, the description of an
interface is interface-name
Interface.
Optional.
The default is HDB3.
Optional.
The default is slave, which is line
clock.
Optional.
Disabled by default.
Optional.
The long keyword applies by
default.