Installing Panels And Modules - Bosch solution 6000 Installation Manual

Solution 6000
Installation Manual

prevent damage to the standoff. (Standoffs and screws
are supplied with each module).
All compatible add on modules will mount on these
spaces. See below for list if modules which can be added
to the control panel.
Module
Solution 6000 Control Panel
CM704B Zone Expander
CM705B Universal Expander
CM710B Output Expander
CM720B LAN Power Supply
CM760B Real Time Clock
CM797B LAN Isolator Module
CM195B RF Receiver Expander
Table 1: Expansion Options
Use the above table to help determine which size cabinet
you will require for the job.
On some export models, one module space will not be
available as the mains transformer mounts in this location.
I N S TA L L I N G PA N E L S A N D M O D U L E S
Once the enclosure is secured in place, install the panels
and modules onto the mounting clip using the supplied
3mm screws. Do not over tighten the screws.
When fitting panels or large modules, you should use 5
mounting clips, one in each corner of the PCB and one
in the middle of the PCB underneath the main terminal
blocks. When mounting small modules, only 4 clips are
required, 1 in each corner.
Both enclosures are supplied with tamper switches,
tamper leads, tamper brackets and a quantity of
mounting clips and screws.
mounting clips and screws may be purchased in bags of
50 clips (10 packs x 5pcs). (P/N: MW890)
The supplied mounting clips are designed to use the
i
3mm machine screws supplied with the enclosure.
Note
The use of self tapping screws will damage the clips.
2-2
Installing the Hardware

Space Occupied
2 Module Spaces
1 Module Space
2 Module Spaces
1 Module Space
1 Module Space
1 Module Space
1 Module Space
1 Module Space
If required, additional
Figure 3: MW720B - Small Enclosure Details
Figure 4: PCB Mounting Clip
The following example shows the MW720B -Small
enclosure configured using 4 small modules.
Bosch Security Systems 07/14 BLCC610I