General Venting - Majestic DV360 Homeowner's Installation And Operating Manual

Vermont Castings Majestic Products DV360/580 Series
Fig. 12 DV580 only, remove deflector top.
FP1032
Flue Pipe
DV580
diverter top
3/2/00 djt
f i r e - p a r t s . c o m
Replace
Screws (4)
Fig. 13 Replacing flue cover and flue pipe.
Your fireplace is approved to be vented either through
the side wall, or vertical through the roof.
•
Only Vermont Castings, Majestic Products
venting components specifically approved and
labelled for this fireplace may be used.
•
Venting terminals shall not be recessed into a wall or
siding.
•
Horizontal venting must be installed on a level plane
without an inclining or declining slope.
10
Deflector Top
FP1032
Replace
Screws (4)
Flue Cover
FP1028

General Venting

Fig. 14 Completed conversion.
After conversion to top vent configura-
tion, the 4" (102mm) flue pipe should be
concentric within the 7" (175mm) outer
collar.
There must not be any obstruction such as bushes,
garden sheds, fences, decks or utility buildings within
24" (610mm) from the front of the termination hood.
Do not locate termination hood where excessive snow
or ice build up may occur. Be sure to check vent termi-
nation area after snow falls, and clear to prevent acci-
dental blockage of venting system. When using snow
blowers, make sure snow is not directed towards vent
termination area.
Location of Vent Termination
It is imperative the vent termination be located observ-
ing the minimum clearances as shown on following
page.
FP1031
20002261