Ember Material Placement; Lava Rock; Flame & Temperature Adjustment; Flame Characteristics - Majestic DV360 Homeowner's Installation And Operating Manual

Ember Material Placement

Place the hard ceramic ember material on the burner in
front of the front logs. Place small dime size ceramic
wool on top of hard ceramic embers. Place small pieces
in hole of top cross log and on front of the front logs by
placing a small piece of wool on your fingertip and
pushing it onto the log. Do not place ember material in
the inside corners of the front logs.

Lava Rock

The lava rock provided with this fireplace must be
placed on the firebox base around the sides of the
burner assembly and on the tray beneath the grate.
Under no circumstances should this lava
rock be placed on any part of the burner
assembly.
Flame & Temperature Adjustment
For fireplaces equipped with Hi/Lo valves, flame adjust-
ment is accomplished by rotating the Hi/Lo adjustment
f i r e - p a r t s . c o m
knob located near the centre of the gas control. (Fig. 46
or 47)
Honeywell Valve
Turn
counterclockwise
to decrease
flame height
Fig. 46 Flame adjustment knob for Honeywell valve.
SIT 820 Valve
Turn
counterclockwise
to increase
flame height
Fig. 47 Flame adjustment knob for SIT valve.

Flame Characteristics

It is important to periodically perform a visual check of
the pilot and the burner flames. Compare them to the
pictorials illustrated below (Figs. 48, 49, 50). If any of
the flames appear abnormal call a service person.
20002261
Vermont Castings Majestic Products DV360/580 Series
Fig. 49 Correct burner flame appearance for DV360 model.
Turn clockwise
to increase
flame height
Fig. 50 Correct burner flame appearance for DV580 model.
Turn clockwise
to decrease
flame height
This appliance venting system is designed and con-
structed to develop a positive flow adequate to remove
flue gases to the outside atmosphere.
Any foreign objects in the venting system, except those
designed specifically for the venting system, may cause
spillage of flue gases.
To inspect the venting system, make sure the main gas
valve is off. Remove window frame assembly (Refer to
Window Frame Assembly Removal Section). Using a
flashlight, check the area above the baffle in the com-
bustion dome. Clean if necessary.
3/8" - 1/2"
SIT Pilot
Fig. 50 Correct pilot flame appearance.
Yellow Flame
LG118
Yellow Flame
Red Glow

Inspecting the Venting System

PSE Pilot
F584-703
Red Glow
LG118
LG121
23