Manual Reset Hard Lockouts - Prestige Solo 110 Installation And Maintenance Manual

9.0 ACVMax Operation
Code Lockout Message
E1 Failed Ignition
E2 False Flame
E3 High Boiler Temperature
E5 Blower Speed
E8 Flame Circuit Error
E9 Gas Valve Circuit Error
E13 Reset Limit Reached
E15 Sensor Drift
E16 Supply Sensor Stuck
E17 Return Sensor Stuck
E18 Sensor Failure
E21 Internal Control Fault
E30 Supply Sensor Shorted
E31 Supply Sensor Open
E43 Return Sensor Shorted
E44 Return Sensor Open
E47 Water Pressure Sensor Error Water pressure sensor is disconnected or broken.
E80 Return > Supply
E87 External Limit Open

Manual Reset Hard Lockouts

The burner failed to light after 5 ignition attempts.
A flame is being detected prior to ignition.
Boiler temperature has reached 210°F [99ºC]
Blower is not at correct speed or speed signal is not being received
by control module.
Flame circuit test failed.
Gas valve circuit test failed.
Resets are limited to 5 every 15 minutes.
Supply or return sensor reading has drifted.
Supply sensor reading is not changing.
Return sensor reading is not changing.
Supply or return sensor reading changed very rapidly.
A / D conversion error.
A short circuit has been detected in the boiler supply temperature
sensor circuit.
An open circuit has been detected in the boiler supply temperature
sensor circuit.
A short circuit has been detected in the boiler return temperature
sensor circuit.
An open circuit has been detected in the boiler return temperature
sensor circuit.
Return temperature is higher than supply temperature.
An external manual reset limit has opened
54
Description