Table of Contents
Advertisement
752
753
754
755
756
757
758
759
760
9-14 Errors
For errors 751-753, Check the
supply tracking
supply marks
black mark sensor position
supply roll for binding.
Press the FEED button and try to continue printing. If
the error continues to appear, change the supply.
Printer sensed a mark in the wrong place.
Printer sensed a mark that is too long.
Printer has a ribbon problem. Check the ribbon for a
jam or remove any slack by turning the take-up reel
clockwise. Load a new ribbon.
Printhead is open. Close the printhead before
continuing. If the error persists, call Technical Support.
The printer is out of supplies. Load supplies.
Load supplies. The calibrated supply length differs by
plus or minus .25 inches from the format. Press the
FEED button to print on the current supply or load new
supply and press the FEED button.
Check supply. Either the supply is not seen or the
on-demand sensor is broken. Check for a label jam.
Clear the supply path or reload supplies. This error
may occur if you remove a label too quickly in
on-demand mode. The printer does not recalibrate
after this error.
Knife is not moving. Call Technical Support.
Knife jam. Call Technical Support.
Advertisement
Table of Contents
