Paxar Monarch 9412 Reference Manual page 126

269
270
271
272
273
282
283
284
285
286
287
288
289
9-8 Errors
Stop bits selection must be 0 (1 bit), or 1 (2 bits).
Resend the communication settings packet or check the
DIP switch settings.
Parity selection must be 0 (none), 1 (odd), or 2 (even).
Resend the communication settings packet or check the
DIP switch settings.
Flow control selection must be 0 (none), 1 (DTR), 2
(CTS/RTS), or 3 (XON/XOFF). Resend the
communication settings packet or check the DIP switch
settings.
Internal code page selection must be 0 (Internal), 1
(ANSI), 2 (DOS 437), or 3 (DOS 850).
Cut adjustment must be -300 to 300 dots.
RS232 Trailer string is too long. Use a maximum of 3
characters.
ENQ Trailer string is too long. Use a maximum of 3
characters.
The buffer type must be T (Transmit), R (Receive), I
(Image), F (Format), or D (Downloadable Fonts).
The storage device type in the memory configuration
packet must be N (non-volatile RAM).
The buffer size is invalid.
The printhead width must be 0.
The battery voltage must be 0 (15-volt battery) or 1
(12-volt battery).
The printer address specified in the communication
settings packet must use exactly six characters.