Yamaha XT250X Service Manual page 51

1. Throttle cable (accelerator cable)
2. Throttle cable (decelerator cable)
3. Meter assembly leads
4. Clutch cable
5. Left front turn signal light lead
6. Main switch lead
7. Right front turn signal light lead
8. Front brake hose
A. Route the meter assembly leads, and main
switch leads from the top of the guide to the
backward of vehicle.
B. To the meter assembly.
C. Install the left front turn signal light lead to the
cap.
D. Route the clutch cable and front left turn signal
light lead at the rear of the guide. However,
route the main switch leads at the front of the
guide.
E. Install the 3-pin coupler for the meter assembly
and left handlebar switch as shown in the illus-
tration.
F. To the headlight.
G. Band the meter assembly leads, handlebar
switch leads (left and right), front brake light
switch lead, front turn signal light leads (left and
right), clutch switch lead, and main switch leads
with plastic locking tie. The plastic locking tie
should position bottom end of the main switch,
and face tail forward.
H. Bottom end of the main switch
I. Install the front right turn signal light lead to the
cap.
J. Never clamp the throttle cable (accelerator
cable) and the throttle cable (decelerator cable)
using plastic locking tie.
K. Position the 3-pin coupler for the meter assem-
bly and left handlebar switch at the front of vehi-
cle.
L. Forward of the vehicle.
M. Face the latchet side of the band outward.
2-32
CABLE ROUTING