Replacing The Front Brake Pads - Yamaha XT250X Service Manual

LT
Brake disc bolt
10 Nm (1.0 m•kg, 7.2 ft•lb)
Apply locking
TITE®)
d. Measure the brake disc deflection.
e. If out of specification, repeat the adjustment
steps until the brake disc deflection is within
specification.
f. If the brake disc deflection cannot be brought
within specification, replace the brake disc.
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
6. Install:
Front wheel
G
Refer to "FRONT WHEEL" on page 4-2.
EAS22280

REPLACING THE FRONT BRAKE PADS

NOTE:
When replacing the brake pads, it is not neces-
sary to disconnect the brake hose or disassem-
ble the brake caliper.
1. Measure:
Brake pad wear limit "a"
G
Out of specification → Replace the brake
pads as a set.
Brake pad lining thickness (inner)
5.3 mm (0.21 in)
Limit
0.8 mm (0.03 in)
Brake pad lining thickness (outer)
5.3 mm (0.21 in)
Limit
0.8 mm (0.03 in)
2. Install:
agent (LOC-
NOTE:
Always install new brake pads, brake pad shims,
and a brake pad spring as a set.
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
a. Connect a clear plastic hose "1" tightly to the
b. Loosen the bleed screw and push the brake
c. Tighten the bleed screw.
d. Install new brake pads, new brake pad
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
3. Lubricate:
4-18
FRONT BRAKE
Brake pad shims
G
(onto the inner brake pads)
Front brake pads
G
Brake pad spring
G
bleed screw "2". Put the other end of the hose
into an open container. The oil pan must be
under the hose end to receive the drain oil.
caliper pistons into the brake caliper with your
finger.
Bleed screw
6 Nm (0.6 m•kg, 4.3 ft•lb)
shims, and a new brake pad spring.
Front brake caliper support bolt
G
1
2