EAS28090
CHECKING THE IGNITION COIL
1. Check:
Primary coil resistance
G
Out of specification → Replace.
Primary coil resistance
0.18–0.27 Ω
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
a. Disconnect the ignition coil connectors from
the wire harness.
b. Connect the pocket tester (Ω × 1) to the igni-
tion coil as shown.
Pocket tester
90890-03132
Positive tester probe
Orange "1"
Negative tester probe
Ignition coil base "2"
c. Measure the primary coil resistance.
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
2. Check:
Secondary coil resistance
G
Out of specification → Replace.
Secondary coil resistance
6.32–9.48 kΩ
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
a. Disconnect the spark plug cap from the igni-
tion coil.
b. Connect the pocket tester (Ω × 1k) to the ig-
nition coil as shown.
Pocket tester
90890-03132
ELECTRICAL COMPONENTS
Positive tester probe
High tension code "1"
Negative tester probe
Orange "2"
c. Measure the secondary coil resistance.
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
3. Check:
Ignition spark gap
G
Out of specification → Follow Step 5 and later
of the ignition system troubleshooting proce-
dure.
Refer to "TROUBLESHOOTING" on page
7-3.
Minimum ignition spark gap
6.0 mm
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
a. Disconnect the spark plug cap from the spark
plug.
b. Connect ignition check "1" to the spark plug
as shown.
Ignition checker
90890-06754
Opama pet-4000 spark checker
YM-34487
7-43