Advertisement
R F I D S u p p l y S p e c i f i c a t i o n s
RFID supplies are available in a variety of sizes. Printing over the RFID inlay
causes printing irregularity. Refer to the RFID Setup Guide & Supply Chart or the
HF Setup Guide & Supply Chart for illustrations to determine which type of RFID
supplies you are using and basic printer configuration information.
Supply Types:
Supply Widths:
Supply Lengths:
Roll Inside
Diameter:
Roll Outside
Diameter:
Ribbon Width:
Ribbon Length:
Additional RFID supplies may be available by request. Contact your RFID
Representative for more information.
T a g C u t D i m e n s i o n s
Use these specifications for the 926™ Knife with the RFMP printer. Use only
Monarch®/Paxar® approved RFID tag supplies.
Widths:
Lengths:
Thickness:
Batch Separator:
Note:
The limited warranty on knives used in or with RFID printers is one (1)
year from the date of shipment, or 500,000 cuts, whichever occurs first.
Thermal Transfer or Thermal Direct
Die Cut or Black Mark
0.75 inch (19 mm) minimum
4.0 inches (102 mm) maximum
1.0 inch (25.4 mm) minimum
13.0 inches (330 mm) maximum
Note:
The supply length depends on the inlay selected.
4.0 inches (102 mm)
8.0 inches (203 mm) maximum
4.3 inches (110 mm) for 4.0 inch (102 mm) supply
23,600 inches (600 meters)
1.5 inches to 4.0 inches (38 mm to 102 mm)
1.5 inches to 16.0 inches (38 mm to 406 mm)
7 mils to 14 mils
3.66 inches (93 mm)
19
Advertisement
