Selecting The Stitch Plate In The User Interface; Threading; Threading The Upper Thread - Bernina 700 Manual

> Press the stitch plate down at the mark back right until it flips up.
> Remove the stitch plate.
> Place the openings of the stitch plate (PunchWork, Optional accessory) above the corresponding guide
pins and press down until it clicks into place.

Selecting the stitch plate in the User Interface

After having changed the stitch plate, it can be checked whether it can be used in combination with the
selected needle.
> Touch the icon «Stitch plate selection».
> Select the attached stitch plate (PunchWork, Optional accessory).
– If the selected needle is suitable in combination with the stitch plate, embroidering can be started.
– If the selected needle is not suitable in combination with the stitch plate, starting the machine is
automatically blocked.

2.8 Threading

Threading the upper thread

Prerequisite:
• The needle and the foot are raised.
• The machine is switched off and disconnected from the power supply system.
> Place the foam pad on the spool pin.
> Place the thread spool on the spool pin so that the thread unwinds clockwise.
> Place the appropriate thread disc.
0371485.0.04_2016-05_Manual_B700
Embroidery preparation
39