Adding A Wi-Fi Network; Manually Adding A Wi-Fi Network - Motorola LEX L10g User Manual

7 If the network security is WEP or WPA/WPA2 PSK, enter the required password and then tap
Connect.
8 If the network security is 802.1x EAP, enter the information below and then tap Connect:
• Tap the EAP method drop-down list and select PEAP, TLS, or TTLS.
• Tap the Phase 2 authentication drop-down list and select an authentication method.
• If required, tap CA certificate and select a Certification Authority (CA) certificate. Note:
Certificates are installed using the Security settings.
• If required, tap User certificate and select a user certificate. Note: User certificates are
installed using the Location & security settings.
• If required, in the Identity text box, enter the username credentials.
• If desired, in the Anonymous identity text box, enter an anonymous identity username.
• If required, in the Password text box, enter the password.
9 Tap .
8.2.3

Adding a Wi-Fi Network

When and where to use: You can add a Wi-Fi Network that is currently out of range or indiscoverable.
Procedure:
1 Tap .
2 Tap .
3 Tap Wi-Fi.
4 Slide the Wi-Fi switch to the On position.
5 Tap +.
6 Enter network SSID and select Security.
7 Tap Save.
The device connects to the wireless network.
8 Tap .
8.2.4

Manually Adding a Wi-Fi Network

When and where to use: Use this procedure to manually add a Wi-Fi network if the network does not
broadcast its name (SSID) or to add a Wi-Fi network when out of range.
Procedure:
1 Tap .
2 Tap .
3 Tap Wi-Fi.
4 Slide the Wi-Fi switch to the ON position.
Send Feedback
MN002858A01-A
Chapter 8: Wireless
139