Ricoh C231 Service Manual page 222

Step 9. Using the right or left arrow, highlight the "Install" pull-down menu and <ENTER>. Use the down arrow
key to select "Save Configuration Changes" and <ENTER>. When all the configuration changes are
completed, you must decide if you want to make them permanent. If you do not complete this step, any
changes you have made during this session will be lost the next time the Controller is turned off. If you do
complete this step, the Controller will remember any changes you have made through all power cycles.
You can change and save the configuration settings of the Controller as often as you wish.
The two remaining Main Menu items, "File" and "Special", provide functions that may be useful during setup or
reconfiguration of the Controller.
The "File" menu has the following items: Print a File, Eject a Page, Info About
-
this Program and Quit (Exit) this Program. Use the "Print a File" command before
saving or exiting the program to test the configuration. Use the "Eject Page" command to clear the Input
Buffer of the Controller or to create a master for a blank page. Choose "Info About this Program" to
check the revision number of the EZ1 program currently installed.
The "Special" menu has the following items: Set Inter-Job Timeout Value and Set
-
Default Table. The factory default setting for Inter-Job Timeout Value is 20 seconds. The inter-job
Timeout value applies only if more than one computer is connected to the Controller. In this case, if
the current print job has paused longer than the Inter-Job Timeout Value and another computer's print job
is waiting, the Controller assumes that current print job is stalled and will terminate it, giving control to
the new print job. Since graphics-intensive print jobs often may pause longer than 20 seconds while
transferring data to the Controller, you may want to use the"Set Inter-Job Timeout Value" menu item to
increase the timeout value. We recommend increasing the value to 120 seconds or greater. The optimal
time for your computer's setting will depend on its speed and how graphics-intensive your print jobs are.
"Set Default Table" applies a set of factory default configurations.
User's Guide 8-5 PCRIP-EZ1