Displaying Voice-Over Events; Changing The Trimming Of Audio Recording Location - Panasonic AJ-HPM100E Operating Instructions Manual

Displaying Voice-Over Events

The voice-over appears in the play list screen as shown below.
1)
2)
1
Play List
• The voice-over is added to the line after an event with an
audio start point.
• The "NO." column shows "+," not an event number.
• TRACK shows the recording channels and audio
connection methods.
• The "SLOT" column shows P2 card slot numbers storing
audio data (same as P2 card slots storing the play list).
2
Timeline
• Extended tracks are indicated in the "EXTRA" part.
• Recorded channel numbers are also shown.
◆ NOTE:
• Use the TRIM button to zoom in (+) and zoom out (–).
Changing the Trimming of Audio
Recording Location
This function allows you to adjust the location of a voice-over
in frame increments (at 24PN in 4-frame increments).
1
4
2
1
Open the play list screen.
2
Select the event you want to change.
3
4
3
Use the following procedure to change offset and
duration.
A normal event
Extended
audio track
Extended
Change of OUT+ TRIM duration
audio track
Extended
Change of IN + TRIM audio start location
audio track
Change of Hold down the IN button and press the
start TRIM+ button or the TRIM– button. The
location: start location is incremented or
decremented in frame increments (in 4-
frame increments at 24PN).
Change of Hold down the OUT button and press the
end TRIM+ button or the TRIM– button. The
location: OUT point is incremented or decremented
in frame increments (in 4-frame
increments at 24PN).
Press the ENTRY button to finalize the change.
◆ NOTE:
• Except for the ENTRY button, you can also use the SET button
or move the pointer with the cross cursor buttons to finalize a
change.
Using Play List: Simplified Voice-Over
75