Removing P2 Cards; Preventing Accidental Deletion - Panasonic AJ-HPM100E Operating Instructions Manual

Removing P2 Cards

◆ NOTE:
• Do not remove P2 cards during access or during recognition
directly after insertion (when the P2 card access LED flashes
orange).
1
Press the STOP button.
When the P2 card access LED of a card to be removed
flashes orange, press the STOP
flashing.
2
Set the card lock to OFF and raise the EJECT button.

Preventing Accidental Deletion

Set the write-protection switch to [PROTECT] to prevent
accidental deletion of data recorded on a P2 card.
PROTECT
button to stop the
Write-protection
switch
3
Press the EJECT button to eject the P2 card.
◆ NOTE:
• Removing a P2 card in the thumbnail screen automatically closes
the thumbnail screen.
• Do not remove P2 cards during access or during recognition
directly after insertion (when the P2 card access LED flashes
orange); otherwise the P2 cards may be damaged. If a P2 card by
any chance is removed during access, [E-30] appears on the LCD
monitor and the LCD panel displays the [AUTO OFF] warning. All P2
card access LEDs will flash rapidly in orange. Turn off the power,
and then turn it back on.
• The clips on a P2 card that was removed during access may no
longer be in the right order. Check the clips and perform the
necessary repair operation.
➝ For details, refer to "Repairing Bad Clips."
• Removing a P2 card during formatting will in most cases destroy the
formatting. Reformat the card after restarting the PC.
◆ NOTE:
• Switching the write-protection switch during recording, playback or
other access operation will not take effect until after these access
operations (playback, recording, etc.) complete.
Introduction: Recording, Playback and P2 Card Handling
29