Time Code - Panasonic AJ-HPM100E Operating Instructions Manual

TIME CODE

This menu sets the time code.
Item
FR SUPER
No. DISP.
0000
0001
500 VITC BLANK
When set to 59.94 Hz Specifies the position where the VITC signal will be inserted.
0000
0006
0010
501 VITC POS-1
When set to 50 Hz
0000
0004
0015
When set to 59.94 Hz Specifies the position where the VITC signal will be inserted.
0000
0008
0010
502 VITC POS-2
When set to 50 Hz
0000
0006
0015
0000
0001
504 RUN MODE
0000
0001
505 TCG REGEN
0002
0001
0002
0003
507 EXT TC SEL
Setting
FR SUPER
No. DISP.
BLANK Specifies whether or not a VITC signal will be output at the positions selected in menu No.
THRU 501 VITC POS-1 and No. 502 VITC POS-2 during playback.
0: VITC signals are not output.
1: VITC signals are output.
NOTE:
• This setting is available only during analog composite output and SD SDI output.
• In EE mode, the input signal is output with the VITC signal.
NOTE:
10L
| | • You cannot select the same line as in menu No. 502 VITC POS-2.
16L • This setting is available only during analog composite output and SD SDI output.
| |
20L
7L
| |
11L
| |
22L
10L NOTE:
| | • You cannot select the same line as in menu No. 501 VITC POS-1.
18L • This setting is available only during analog composite output and SD SDI output.
| |
20L
7L
| |
13L
| |
22L
REC Specifies an operating mode that advances the internal time code generator.
0: The internal time code generator is advanced only during recording.
FREE
1: When the power is on, the internal time code generator is advanced regardless of
operating mode.
TC&UB Specifies the signal to regenerate when the time code generator (TCG) is in the REGEN
mode.
TC
0: Regenerates both the time code and the user bit
UB
1: Regenerates only the time code
2: Regenerates only the user bit
EXT_L Specifies the time code used when an external time code is used.
0: LTC of the TIME CODE IN connector
SLTC
1: LTC data attached to serial signal input to HD SDI IN
SVITC
2: VITC data attached to serial signal input to HD SDI IN
NOTE:
When SLTC and SVITC are set, the VITC in the input video signal is used when an analog
composite or SD SDI input signal is selected. When 1394 is selected as the input signal,
the IEEE 1394 digital input signal time code is used regardless of this setting.
* An underlined setting indicates an initial value.
Settings and brief function description
101
Setup: Item Settings