Revising Split Points (Changing Registered Point); Trimming The Audio Split Point - Panasonic AJ-HPM100E Operating Instructions Manual

Revising Split Points (Changing Registered Point)

You can add an audio split to an event registered in the play
list and change the audio split point.
1
2 3,5

Trimming the Audio Split Point

You can change audio split points in frame increments (in 4-
frame increments at 24PN).
1
2,3
1
Open the play list screen.
2
Use the cursor buttons to select the event where you
want to change the split point.
4
4
1
Open the play list screen.
2
Use the cursor buttons to select the event where you
want to add (or change) a split point.
3
Press the EVENT button.
This activates the event register mode.
4
Register the audio split point.
Use the operation buttons or search dial to look for a
location for an audio split point. Then hold down the SPLIT
button and press the ENTRY button.
5
Press the EVENT button to end registration.
◆ NOTE:
• Addition can take place even when the IN point is changed
before step 4 or the OUT point is changed after step 4.
3
Change the split point.
Hold down the SPLIT button and press the TRIM+ button
or the TRIM– button. The IN point is incremented or
decremented in frame increments (in 4-frame increments
at 24PN).
◆ NOTE:
• During trimming the split point is indicated in black numerals
against a yellow background in the event list display of the event
list split screen.
4
Press the ENTRY button to finalize the change.
◆ NOTE:
• Trimming cannot be performed beyond the start point of an
original clip.
• Trimming cannot be performed in the event register mode.
Using Play List: Audio Split Editing
71