Table of Contents
Advertisement
Appendix E: T1000 Optional Installation Kit Instructions
The T1000 can be installed in several configurations with the aid of optional installation kits.
E.1 Optional 3-Module Tower Cap Kit - 93178
T1000 Series UPS Tower Cap Installation Instructions - 94037-000
An Optional Tower Cap Kit are available for 3-module T1000 tower systems. If
the optional Caster Kits are to be used, the casters should be installed before the Tower Cap is installed.
1 Tower Cap Kit
The tower configuration modules are arranged side by side, and secured by a press-fit cap over the as-
sembly.
2 Contents - Tower Cap Kit (1 Cap per UPS System)
1 ea.: T1000 Series UPS Tower Cap Installation Instructions - 94037
1 ea.: 93178 - Tower Cap for 3 module System
3 Install Tower Cap
NOTE: If optional Caster Kits, P/N 90508, are to be used, install them before installing the Tower Cap.
1. Unpack the T1000 modules and set them in the desired location with the faceplates at the top as
shown below. (Figure 2-A)
2. Facing the front of the modules, arrange them left to right in the following order:
•
Transformer Module (if available)
•
Power Module
•
Battery Module with output panel(if available)
•
Second Battery Module without output panel (if available)
3. Locate the front of the Tower Cap. The front of the Cap has three tabs extending beyond the skirt
line. See Figure 1.
4. Fit the Tower Cap over the T1000 Modules, beginning with the front and lower the bak end over the
top back of the modules.
5. Press the T1000 Tower Cap over the tower modules (Figure 2-B).
6. TThe T1000 tower is ready for installing the interconnecting cables. See the T1000 Installation and
Operation Manual - 91074.
A
FIGURE. 2: INSTALL CAP ON THREE MODULE TOWER SYSTEM
T1000 Series UPS Installation and Operation Manual – 91074-002
FRONT
FIGURE 1: TOWER CAP FRONT - DETAIL
B
C
E-1
Advertisement
Table of Contents
