Toshiba t1000 Installation And Operation Manual page 24

holes at the desired level. Clip 2 cage nuts spaced vertically 4 in. apart on each Post.
2. If more than one module is being installed for the T1000 system, install the next pair of cage nuts 3
Rack Units (5 1/4") above the first set of cage nuts for the next module.
3. Repeat Steps 1-2 for each T1000 module to be installed. Continue until cage nuts for all the modules
in the system have been clipped on the 4-Post rack.
Prepare the Module(s)
4. Attach the front and rear bracket to the left and right sides of the T1000 module as shown in Fig. 6-9.
Use the mounting hardware from Kit 93863 to secure the brackets to the mounting holes indicated in
Fig. 6-8 and Table 6-1.
5. Secure the Front Brackets, P/N 68844, to the left and right front side of the module at Fig. 6-9 (1) using
four Phillips 8-32 x 1/4" screws.
6. Secure the Rear Brackets, P/N 92746, to the left and right rear side of the module at Fig. 6-9 (2) using
1 Phillips 8-32 x 1/4" screw each in the top and bottom slot, and use a Phillips 10-32 x 1/2" in the center
slot (Fig. 6-9 (3)).
Install the Module(s) in the 4-Post Rack
CAUTION: Battery Modules weight 150 lb. (68 kg). Use lifting aids and proper lifting techniques.
7. Follow the vertical arrangement of T1000 modules as discussed in Section 6.1. Mount the lowest mod-
ule in the 4-Post rack to the bottom pair of cage nuts on each Post using the 1/4"-20 x 5/8" hex bolts,
(P/N 33798).
8. Repeat Step 7 for the remaining modules, working from bottom to top. (Fig. 6-10)
9. Go to Section 7 for cabling instructions.
FIGURE. 6-9: FIXED MOUNTING BRACKETS - 4-POST RACK
14
3
Front Bracket
1
68844
Four ea.
Phillips 8-32 x 1/4" screws
T1000 Series UPS Installation and Operation Manual – 91074-002
Rear Bracket
92746
2
Side Slots - use two ea.
Phillips 8-32 x 1/4" screws
Center Slots - use one ea.
Phillips 10-32 x 1/2" screws