Table of Contents
Advertisement
ATERIAL - VINYL OR POLYESTER
MPERATURE - MINUS 20 TO 100 deg. C
HESIVE - L-344 OR EQUIV.
UST RESIST OIL SOLVENTS
L MATERIALS USED MUST
UL RECOGNIZED
ARNING AREA BACKGROUND COLOR: ANSI DANGER RED
ARNING AREA TEXT COLOR: ANSI WHITE
XT AREA BACKGROUND COLOR: ANSI WHITE
XT AREA TEXT COLOR: ANSI BLACK
ORNER RADIUS: VENDOR STANDARD
4.50
MATERIAL - VINYL OR POLYESTER
EMPERATURE - MINUS 20 TO 100 deg. C
DHESIVE - L-344 OR EQUIV.
MUST RESIST OIL SOLVENTS
LL MATERIALS USED MUST
E UL RECOGNIZED
Only qualified technicians familiar with this equipment and the
information supplied with it should be permitted to install and
AUTION AREA BACKGROUND COLOR: ANSI CAUTION YELLOW
operate this equipment.
AUTION AREA TEXT COLOR: ANSI BLACK
Installation of electrical equipment must be done in
EXT AREA BACKGROUND COLOR: ANSI WHITE
accordance with National Electrical Code and any other state
or local codes. Proper grounding and conductor sizing must
EXT AREA TEXT COLOR: ANSI BLACK
be installed for safe operation.
ORNER RADIUS: VENDOR STANDARD
DRAWN:
During operation, keep all covers in place and cabinet
VB 3-10-94
doors shut.
THIS MATERIAL IS THE EXCLUSIVE PROPERTY OF TOSHIBA INTERNATIONAL
When performing visual inspections and maintenance, if
CORPORATION AND SHALL NOT BE REPRODUCED, USED, OR DISCLOSED
possible, be sure the UPS is turned off and the incoming
TO OTHERS UNLESS PRIOR WRITTEN AUTHORIZATION IS OBTAINED.
87840
10-13 JE
AC feed is turned off and locked out.
The UPS and Battery Cabinet will have hazardous
ECN
DATE
BY
13131 WEST LITTLE YORK ROAD, HOUSTON, TX 77041 U.S.A.
voltages present even after the AC feed is turned off.
If it is necessary to make measurements with the power
on, do not touch any electrical connection points. Remove
all jewelry from wrists and fingers. Make sure test equipment
is in good, safe operating condition.
While servicing, stand on some type of insulation, and be
sure not to be grounded.
Follow the safety instructions given in the equipment manual
carefully and observe all danger, warning and caution notices.
0.00
CAUTION
AREA
TEXT AREA
DRAWN:
CHECKED:
JK 12-29-93
THIS MATERIAL IS THE EXCLUSIVE PROPERTY OF TOSHIBA INTERNATIONAL
CORPORATION AND SHALL NOT BE REPRODUCED, USED, OR DISCLOSED
TO OTHERS UNLESS PRIOR WRITTEN AUTHORIZATION IS OBTAINED.
0
10-13 JE
DATE
BY
13131 WEST LITTLE YORK ROAD, HOUSTON, TX 77041 U.S.A.
DRAWN:
CHECKED:
VB 3-10-94
WLM 11-13
4
THIS MATERIAL IS THE EXCLUSIVE PROPERTY OF TOSHIBA INTERNATIONAL
CORPORATION AND SHALL NOT BE REPRODUCED, USED, OR DISCLOSED
TO OTHERS UNLESS PRIOR WRITTEN AUTHORIZATION IS OBTAINED.
10-13 JE
DATE
BY
13131 WEST LITTLE YORK ROAD, HOUSTON, TX 77041 U.S.A.
2.00"
LABELS IN ENGLISH
D A N G E R
Risk of electrical shock.
Live terminals on batteries.
Do not touch uninsulated battery
terminal.
DANGER
HAZARDOUS VOLTAGES
Hazardous voltages are used in the operation
of this equipment and could cause severe personal
injury or loss of life.
The following precautions should be observed to
reduce the risk of injury or death.
TITLE:
CHECKED:
APPROVED:
WLM 11-13
WLM 11-13
2.00"
C A U T I O N
Risk of electrical shock.
Battery circuit is not isolated from AC input,
hazardous voltage may exist between
battery terminals and ground.
Test circuit before touching.
TITLE:
APPROVED:
FIGURE 2-1: (CONT.) EQUIPMENT WARNING LABELS
WLM 11-13
WLM 11-13
TITLE:
APPROVED:
CAUTION LABEL
WLM 11-13
PLP
ECO 89088
ECN
MATERIAL - VINYL OR POLYESTER
TEMPERATURE - MINUS 20 TO 100 deg. C
ADHESIVE - L-344 OR EQUIV.
MUST RESIST OIL SOLVENTS
ALL MATERIALS USED MUST
BE UL RECOGNIZED
WARNING AREA BACKGROUND COLOR: ANSI DANGER RED
WARNING AREA TEXT COLOR: ANSI WHITE
TEXT AREA BACKGROUND COLOR: ANSI WHITE
TEXT AREA TEXT COLOR: ANSI BLACK
0.75"
CORNER RADIUS: VENDOR STANDARD
PN 40759
4.75
WARNING AREA
MATERIAL - VINYL OR POLYESTER
TEXT AREA
TEMPERATURE - MINUS 20 TO 100 deg. C
ADHESIVE - L-344 OR EQUIV.
MUST RESIST OIL SOLVENTS
ALL MATERIALS USED MUST
BE UL RECOGNIZED
Seulement des techniciens qualifiés et familiarisés avec ce
matériel, ainsi que la documentation fournie avec elle,
CAUTION AREA BACKGROUND COLOR: ANSI CAUTION YELLOW
devraient être autorisés à installer et à utiliser cet équipement.
CAUTION AREA TEXT COLOR: ANSI BLACK
L´installation de l´équipement électrique doit être effectuée
selon les normes électriques reconnues par les organismes
TEXT AREA BACKGROUND COLOR: ANSI WHITE
nationaux ou provinciaux accrédités. Une bonne mise à la
TEXT AREA TEXT COLOR: ANSI BLACK
terre et un calibre de câble approprié doivent être installés
CORNER RADIUS: VENDOR STANDARD
pour un fonctionnement sécuritaire.
DRAWN:
DANGER LABEL
JEE-10-14-13
Pendant le fonctionnement, maintenir tous les couvercles en
place et les portes de l´armoire fermées.
THIS MATERIAL IS THE EXCLUSIVE PROPERTY OF TOSHIBA INTERNATIONAL
PLP
CORPORATION AND SHALL NOT BE REPRODUCED, USED, OR DISCLOSED
Lors des inspections visuelles et d´entretien, si possible,
TO OTHERS UNLESS PRIOR WRITTEN AUTHORIZATION IS OBTAINED.
vérifier que l´UPS soit éteinte et que l´alimentation AC est
DRAWING NO.:
40759
éteninte et verrouillée.
ECN
DATE
BY
L´UPS et l´armoire de batterie auront des tensions
dangereuses présentes même après avoir coupé
l´alimentation AC.
Si des mesures sur l´appareil sous tension doivent être
effectuées, ne toucher à aucun point de connexion
électrique. Retirer tous les bijoux des poignets et des doigts.
S´assurer que l´équipement de test est en bon êtat de
fonctionnement.
. L ors des opérations de maintenance, l´opérateur doit se tenir
sur une surface isolée non reliée à la mise à la terre.
Suivre attentivement les consignes de sécurité indiquées
40308
dans le manuel d´opération et respecter tous les avis de
danger, les avertissements et les mises en garde.
0.00
CAUTION
AREA
TEXT AREA
0.75"
PN 40760
DRAWN:
DANGER LABEL
JEE 10-14-13
GENERAL - UPS
THIS MATERIAL IS THE EXCLUSIVE PROPERTY OF TOSHIBA INTERNATIONAL
CORPORATION AND SHALL NOT BE REPRODUCED, USED, OR DISCLOSED
TO OTHERS UNLESS PRIOR WRITTEN AUTHORIZATION IS OBTAINED.
DRAWING NO.:
ECN
DATE
BY
13131 WEST LITTLE YORK ROAD, HOUSTON, TX 77041 U.S.A.
SCALE:
DRAWN:
CHECKED:
JEE 10-14-13
WLM 4-07-14 WLM 04-14
T1000 Series UPS Installation and Operation Manual – 91074-002
THIS MATERIAL IS THE EXCLUSIVE PROPERTY OF TOSHIBA INTERNATIONAL
REV:
CORPORATION AND SHALL NOT BE REPRODUCED, USED, OR DISCLOSED
TO OTHERS UNLESS PRIOR WRITTEN AUTHORIZATION IS OBTAINED.
04-14
ZIR
DRAWING NO.:
40760
DATE
BY
13131 WEST LITTLE YORK ROAD, HOUSTON, TX 77041 U.S.A.
2.00"
ÉTIQUETTES EN FRANÇAIS
D A N G E R
Risque de choc électrique.
Bornes de batteries sous tension.
Ne pas toucher de borne de batterie non
isolée.
DANGER
TENSIONS DANGEREUSES
Des tensions dangereuses sont utilisées dans
l´opération de cet appareil et pourraient causer
des blessures graves ou des pertes de vie.
Les mesures de sécurité suivantes doivent être
observées pour réduire le risque de blessure ou de
mort.
CHECKED:
APPROVED:
SCALE:
WLM 11-13
WLM 11-13
2=1
1
REV:
13131 WEST LITTLE YORK ROAD, HOUSTON, TX 77041 U.S.A.
2.00"
AT T E N T I O N
Risque de choc électrique.
Le circuit de la batterie n´est pas isolé de
l´entrée AC, des tensions dangereuses
peuvent exister entre les bornes de la
batterie et la masse.
Tester le circuit avant de toucher.
TITLE:
CHECKED:
APPROVED:
SCALE:
WLM 11-13
WLM 11-13
FULL
1
REV:
40308
TITLE:
APPROVED:
2=1
CAUTION LABEL
PLP-FRENCH
1
0.75"
PN 90637
WARNING AREA
TEXT AREA
TITLE:
DANGER LABEL
PLP-FRENCH
DRAWING NO.:
90638
0.75"
PN 90636
DANGER LABEL
GENERAL - UPS-FRENCH
DRAWING NO.:
DRAWING NO.:
90636
906
90
SCALE:
2=1
1
REV:
Advertisement
Table of Contents
