Suzuki Ozark Service Manual page 206

7-42 CHASSIS
HANDLEBARS
When installing the lower handlebar holder 1 to the steering
shaft, the higher mating portion must face to forward.
• Set the handlebars to match its punched mark 2 to the mat-
ing face of the handlebar clamps.
• First tighten the bolts 3 to the specified torque and then
tighten the bolts 4 to the specified torque.
 Handlebar clamp bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Install the steering head cover with the projection A inserting
into the cushion B on the steering head cover bracket.
NOTE:
The indicator light position on the steering head cover is shown
on page 8-24.
• Install the handle switch with the lug 5 on the switch half
inserted into the hole 6 on the handlebars.
NOTE:
After installing the handlebars, make sure that the cable, wiring
harness and brake hose routing are properly. (9-12 to 9-18)
• Install the steering head cover.
• Align the mating face of the reverse cable bracket with the
punched mark C on the handlebars.
• First tighten the bolt D then the other, so that the bracket has
a clearance as shown in illustration.
Forward
Clearance
Handlebars