Suzuki Ozark Service Manual page 205

• Apply SUZUKI SUPER GREASE "A" to the steering shaft
holders and dust seals before remounting the steering shaft
holders.
 99000-25030: SUZUKI SUPER GREASE "A" (USA)
99000-25010: SUZUKI SUPER GREASE "A" (Others)

To prevent the entry of dirt, the dust seal end A must
face forward when installed to the steering shaft.
• Tighten the steering shaft holder bolts to the specified torque.
 Steering shaft holder bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
NOTE:
Make sure that the wiring harness, cables and brake hose rout-
ing are properly. (9-12 to 9-18)
TIE ROD
• Tighten the tie rod end nuts to the specified torque.
 Tie rod end nut: 35 N·m (3.5 kgf-m, 25.5 lb-ft)
• Install the cotter pins.

Replace the removed cotter pins with new ones.
NOTE:
When installing the tie rod, make sure the narrow end 1 of the
tie rod comes out.

The locknuts 2 with a yellow finished surface have
left-hand threads.
CHASSIS 7-41