Suzuki Ozark Service Manual page 139

• Install the gear case cover and tighten its bolts to the speci-
fied torque in a crisscross pattern. (4-14)
NOTE:
* Do not install the new O-ring to the gear case cover at this
time.
* Do not apply a thread lock to the case cover bolts at this time.
 Gear case cover bolt: 25 N·m (2.5 kgf-m, 18.0 lb-ft)
• Remove the gear case cover. (4-5)
• Measure the thickness of compressed solder with the
micrometer.
 09900-20205: Micrometer
• Select the proper size of shim from the right chart, according
as the compressed solder thickness.
• After selecting the proper size of shim, install it on the ring
gear back side.
DRIVE TRAIN 4-19
For left side of ring gear (
Part No. Shim thickness
1.26 mm (0.0496 in)
1.32 mm (0.0520 in)
1.38 mm (0.0543 in)
1.44 mm (0.0567 in)
27407-05820
1.50 mm (0.0591 in)
(Shim set: 10 pcs)
1.56 mm (0.0614 in)
1.62 mm (0.0638 in)
1.68 mm (0.0661 in)
1.74 mm (0.0685 in)
1.80 mm (0.0709 in)
4-21)