Table of Contents
Advertisement
1) Remove the thumb screw from the fan transfer tray.
2) Slide fan transfer tray fully out through the bottom louver opening.
3) Mount the fan bracket onto the fan transfer tray using the two locating pins (see Diagram 1).
4) Slide the Control Switch Box onto the Control Switch Box Mounting Bracket located on the front of the fan transfer tray and
secure with the #8 x 3/8" screw
Locating Pins
Control Box
mounting bracket
Control
Box
5) Secure wiring to fan tray with supplied strain reliefs.
6) Secure both ground wires to ground lug. Bolt onto unit.
7) Plug fan into receptacle box (see note at top of page).
8) Slide thermodisc/cover assembly into the bracket clip on
the underside of the firebox. Ensure that no wires will come
in contact with any hot surfaces. See Diagram 3.
9) Reinstall the thumb screw.
FAN
Low Speed Red Wire not
connected.
SWITCH CONTROL BOX
918-437
FAN INSTALLATION
FAN INSTALLATION
NOTE: If optional Ashtray is installed, it must be removed before installing the fan.
The receptacle Box must be replaced with one that will accept the fan cable.
provided (see Diagram 1).
Thumb Screw
GREEN
GROUND
THERMODISC
GREY
M
BLUE
Diagram 2
POWER CORD
Fan transfer tray
Diagram 1
GREY
BROWN
GROUND
GREEN
installation
FP90
Diagram 3
11.10.14
FP90 Wood Fireplace |
|
27
27
Hide quick links:
Advertisement
Table of Contents
