JUKI AMS-221EHL Manual page 55

Adjustment Procedures
How to install the Y-LM guide
1. Butt the Y-LM guide A
2. Adjust the distance to 192mm between the Y-LM guide A
Y-LM guide B , and secure parallelism.
3. Fasten the Y-LM guide B
How to install the X-LM guide
1. Butt the X-LM guide A
setscrews .
2. Adjust the distance to 70mm between the X-LM guide A
X-LM guide B , and secure parallelism. Then, tighten 8 setscrews
.
3. Secure parallelism between the bed processing face A and the X-LM
guide A . Then, tighten 8 setscrews
to the bed and fasten it with screws.
with screws.
to the X movement base
.
o If no parallelism is secured, this
and the o If no parallelism is secured,
and tighten 8
and the
– 51 –
Results of Improper Adjustment
can be a cause of feed error.
needle entry accuracy will be
lowered.