Table of Contents
Advertisement
3. Feeding frame lifting setup at the end of sewing
Using the memory switch U37, it is possible to set up the timing for feeding frame lifting
at the end of sewing.
Setup
After the start of
sewing reset
Before the start of
sewing reset
Pedal operation after the The feeding frame is lifted by the pedal
start of sewing reset
4. Feeding frame lifting setup at the time of temporary stop
Using the memory switch U41, it is possible to set up the timing for feeding frame lifting
when it has been set up with a temporary stop command in the pattern data.
Setup
Lifting
Pedal operation
5. Feeding frame lifting prohibition setup
Using the memory switch U38, it is possible to make setting up with the feeding frame
kept lowered at all times.
Setup
Pedal operation
Always lowered
Contents
The feeding frame is lifted after the movement
from the end of sewing to the start of sewing.
The feeding frame is lifted at the end of sewing.
The movement is forwarded from the end of
sewing to the start of sewing with the feeding
frame left lifted.
after the movement from the end of sewing
to the start of sewing.
Contents
The feeding frame is lifted immediately
with the temporary stop command.
Lifted by pedal operation with the temporary
stop command. Sewing is started by the start
pedal with the feeding frame left lowered.
Contents
It is possible to lift or lower the feeding
frame by pedal operation.
The feeding frame is kept lowered even
after origin retrieval and moving at the
sewing start. Lifting and lowering of the feeding
frame by pedal operation are also disabled.
Explanation
Explanation
Explanation
– 102 –
Advertisement
Table of Contents
