Table of Contents
Advertisement
Adjustment Procedures
1. Move the X movement base
2. Move the X movement base
right side hole of the bed coincide with the position of the adjusting
screw
.
3. Loosen 4 setscrews
4. Turn the adjusting screw
point when a load of 9.8N (1kg) is applied to the center of the X
timing belt
by means of a spring balance.
Turning the setscrew
and turning it in Direction B causes the warp to increase.
5. Tighten the setscrew
Adjustment Procedures
1. Move the X movement base
2. Loosen 4 setscrews
3. Turn the adjusting screw
point when a load of 9.8N (1kg) is applied to the center of the Y timing
belt
by means of a spring balance.
Turning the setscrew
and turning it in Direction B causes the warp to increase.
4. Tighten the setscrew
to left side.
forward and backward, and let the
.
to secure a warp of 2mm at the load
in Direction A causes the warp to decrease,
and check the amount of warp again.
to the extreme inner part.
.
to secure a warp of 2mm at the load
in Direction A causes the warp to decrease,
and check the amount of warp again.
o IIf the tension is too much, this can
o If the tension is too less, this can
o If the tension is too much, this can
o If the tension is too less, this can
– 47 –
Results of Improper Adjustment
cause destruction in the X timing
belt
.
be a cause of feed error.
Results of Improper Adjustment
cause destruction in the Y timing
belt
.
be a cause of feed error.
Advertisement
Table of Contents
