Table of Contents
Advertisement
1. For incorporating the AT solenoid unit
solenoid unit to the rear end of the machine arm.
2. The center-to-center distance between the AT joints
When the AT joints
correct, and that the front and rear of the AT joints
malfunction resulting in incorrect thread tension.
(When the AT joint
3. For the pin block of the AT link unit (rear)
The wrong pin position may cause AT malfunction resulting in incorrect thread tension.
4. After completion of all assembly work, make sure that the thrust collar
noid unit
. If there is a clearance between them, loosen 2 setscrews
to the rear (Arrow
F
* If the above-mentioned center-to-center distance is great between the AT joints
opened wider.
Procedures of assembling
into the system, run the solenoid cable
are disassembled or assembled, make sure that the center-to-center distance is
is turned 4 times, the feed move amount comes to attain 2mm.)
) and secure it again.
of the AT connector rod
are parallel. Failure to observe this may cause AT
, use the pin block
for H type and the pin block
478.9mm
Secure parallelism between plane and plane.
– 41 –
from the rear of the AT
is 478.9 mm.
closely contacts with the AT sole-
and move the AT solenoid unit
, the clearance will be
Close contact
for S type.
Advertisement
Table of Contents
