Rinnai infinity 16 User Instruction page 24

W TESTING
0 Turn on Gas and Water,
0 Test for water leaks and gas
escapes. Use soapy water to check
for gas leaks.
0 Remove pressure test point
screw, attach pressure gauge to
test point.
0 Turn power on (Caution 230V
inside unit).
l Turn Infinity
16 on at Kitchen
Remote Control. Set temp to 75%
(See page 7 and 8).
Open any hot water tap fully.
0 Check test point pressure.
Information is provided in a pouch,
rear of front panel.
l If the pressure
is low, there
could be various reasons eg. warm
incoming water, low,water flow, gas
pipes too small.
Water flow will need to be at least 6
litres/min if incoming water temp. is
15oc.
0 If it is established that the gas
pressure needs adjusting, follow the
instructions EXACTLY according
to the information provided in the
pouch, rear of front panel.
IF IN DOUBT, CONTACT RINNAI.
0 Turn hot water off. Turn power
off. Remove pressure gauge and
replace test point screw.
0 Replace front cover (4 stews).
0 Turn power on. Turn Infinity 16
ON at Remote Control.
0 Check operation of appliance by
ensuring that the Remote Control(s)
are functioning correctly.
0 Explain the operation of the
Infinity 16 to the customer. Make
sure the customer understands the
instructions, in particular the
instructions for the Remote Control(s).
FAULT/FAILURE PROCEDURE
If you are unable to get the Infinity
16 to operate correctly, contact
Rinnai, or your local agent.
Test
point
Screw and washer
SET CONTROL
HOT WATER TAP OPEN
NOTE: The regulator is factory pre-set, it
should not need adjusting. Check incoming
pressure before attempting to make any
change to the appliance regulator.
- 23