Rinnai infinity 16 User Instruction page 23

n
CONNECTING REMOTE CONTROL
CABLE TO THE INFINITY 16.
l
Disconnect power.
0 Remove the cover from the
Infinity 16 (4 screws) (fig 1).
0 Remove plastic cover from PCB
and electrical connections.
l
Thread the cable through the
(fig 1)
cable access hole at the base of
the Infinity 16, then connect to the
Remote Control terminal on the right
hand side of P.C.B. unit (fig 2).
0 Horse shoe lugs must be used
at both the water heater connection
and the Kitchen Control.
Short circuits and bad connections
Remote
caused by bare wires may cause
Control Cable
the heater to malfunction.
0 Replace plastic cover.
(fig 2)
l
Secure cable inside Infinity 16
using the clamp provided.
Single wire connection, shown
connected.
Piggy-back the connection in case
of two Remote Controls. (Optional
Remote Control is availabe
separately.)
n
Purge Gas and Water pipes to
WATER ON
GAS ON
remove air and swarf. Swarf in either
gas or water supplies may damage
the Infinity 16.
- 22