Avaya H.323 9608 Installing And Maintaining page 31

4. The deskphone activates the Ethernet line interface, the PC Ethernet jack, and dial
5. The IP deskphone sends a request to the DHCP server and invokes the DHCP
6. The system determines the DHCP protocol, IPv4 or IPv6, and the applicable
Installing and Maintaining Avaya IP Deskphone H.323 9608, 9611G, 9621G, and 9641G
pad input to allow the start of procedures. The activation occurs as soon as possible
after power-up or a reset.
The deskphone displays the speed of the Ethernet interface in Mbps, that is, 10,
100, or 1000. The deskphone then displays the message
until the software determines whether the interface is 10 Mbps, 100 Mbps,
program
or 1000 Mbps.
Note:
The Ethernet speed is the LAN interface speed for both the deskphone and any
attached PC, if the administrator has not disabled the latter interface by a
PHY2STAT setting.
Important:
When you press the star (*) after the system displays a
The initialization process can support an interrupt that invokes the Craft Access
entry procedure to allow manual settings, only if the local dialpad procedure
status (PROCSTAT) system value is 0. The zero PROCSTAT value provides full
access to local procedures. If PROCSTAT is 1 the Craft Access entry procedure
can be invoked only when a
procedure is available. For information, see
Administrative (Craft) Options.
process.
The deskphone displays one of the following messages:
• DHCP: s secs * to program
• or
DHCP: s secs VLAN ID = n
• or
DHCP: s secs
where s is the number of seconds that have elapsed since DHCP process was
started. The deskphone displays the first message if 802.1Q tagging is off and
access to local programming procedures is not disabled or restricted. For more
information, see Chapter 3: Using Local Administrative (Craft) Options .
page 37 The deskphone displays the second message if 802.1Q tagging is on
and access to local programming procedures is disabled or restricted. If the first and
second message alternate every two seconds, 802.1Q tagging is on. When both
messages are displayed alternately, access to local programming procedures is not
disabled or restricted. Finally, the deskphone displays the third message if 802.1Q
tagging is off and access to local programming procedures is disabled or
restricted.
parameters enabled.
Understanding the plug in and reset process
message displays but only the VIEW
* to program
Chapter 3: Using Local
on page 37
No Ethernet * to
message.
* to program
on
August 2013 31