HP ProLiant WS460c Gen9 Maintenance And Service Manual page 71

Align the system board, and then slide it into place inside the base pan.
3.
While holding the system board in place, turn the base pan on the side and install the two screws
4.
on the bottom of the base pan.
Place the graphics server blade on a flat level surface.
5.
IMPORTANT: Install all components in the same configuration prior to removing the system
board.
Install the front panel/drive cage assembly
6.
Install the heatsink blank
7.
Install the storage controller or connect the direct connect SATA cable
8.
cabling" on page 80).
Install all DIMM baffles
9.
Install the internal USB drive.
10.
Install the drives ("Drive" on page 33).
11.
Install the drive blanks
12.
("Front panel/drive cage
("Heatsink blank" on page 51).
("DIMM baffles" on page 51).
("Drive blank" on page 32).
assembly" on page 54).
("Direct connect SATA
Removal and replacement procedures 71