HP ProLiant WS460c Gen9 Maintenance And Service Manual page 69

Remove the heatsink blank, if installed
10.
Remove the front panel/hard drive cage assembly
11.
While holding the system board in place, turn the base pan on its side and remove the two system
12.
board screws from the bottom of the base pan.
Place the graphics server blade on a flat, level surface.
13.
Slide the system board approximately 1.27 cm (0.50 inches) towards the rear of the server and lift
14.
the system board from the base pan.
Remove the three T-10 screws from the outside of the base pan, and then remove the server
15.
blade release lever bracket.
("Heatsink blank" on page 51).
("Front panel/drive cage
Removal and replacement procedures 69
assembly" on page 54).