HP ProLiant WS460c Gen9 Maintenance And Service Manual page 60

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent possible server malfunction, do not mix processors of different
speeds or cache sizes. Refer to the label on the processor heatsink for a description of the
processor.
CAUTION: To prevent possible graphics server blade overheating, always populate each
processor socket with a processor socket cover and a heatsink blank or a processor and a
heatsink.
CAUTION: To prevent damage to electrical components, properly ground the graphics
server blade before beginning any installation procedure. Improper grounding can cause
ESD.
IMPORTANT: Processor socket 1 must always be populated. If processor socket 1 is
empty, the graphics server blade does not power up.
For any memory configuration and processor model, the memory speed will run at 2133MHz. For more
information, see the HPE ProLiant WS460c Gen9 Graphics Server Blade User Guide on the Hewlett
Packard Enterprise website (http://www.hpe.com/support/WS460cGen9/docs). For more information
about graphics server blade memory, see the Hewlett Packard Enterprise website
(http://www.hpe.com/info/memory).
To remove the component:
Update the system ROM.
1.
Locate and download the latest ROM version from the Hewlett Packard Enterprise Support Center
website (http://www.hpe.com/support/hpesc). Follow the instructions on the website to update the
system ROM.
Power down the graphics server blade (on page 25).
2.
Remove the graphics server blade
3.
Place the graphics server blade on a flat, level work surface.
4.
Remove the access panel
5.
Do one of the following:
6.
Remove the storage controller
o
Disconnect the direct connect SATA cable
o
Remove the internal USB drive, if installed. To locate the internal USB connector, see "System
7.
board components (on page 91)."
Remove all DIMM baffles
8.
Remove the heatsink ("Heatsink" on page 57).
9.
("Remove the graphics
("Access panel (graphics server
("Storage controller" on page 50)
("Direct connect SATA
("DIMM baffles" on page 51).
blade" on page 26).
blade)" on page 31).
cabling" on page 80).
Removal and replacement procedures 60