Preventative Maintenance - Vulcan-Hart RE-3 Owner's Manual

pREVENTATIVE MAINTENANCE:

1) Do a routine check on general appearance, moving parts and check to see if any nuts
or screws have worked themselves loose.
2) HOTpLATES:
Check that the hotplates and switches are working correctly by setting each control
to low (1) and noting that the plates heat up.
3) HOTpLATE REpLACEMENT:
Hotplates 640 x 330mm
Remove the front curb, back splash plate and panel above the door.
Disconnect at terminals and lift hotplate completely out of the unit.
Dismantle hotplate and replace defective element.
On clamping plate and elements together, fully tighten nuts and then release one full
turn before locking with locknut.
On replacement, be careful to group terminal wires together under spillage channel.
Ensure that the earth wire is connected.
It may be necessary to level plates on replacement.
Use straight edge across top of plates, adjust on the four corner adjusting screws.
When levelled, tighten locknuts.
Hotplate 220mm diameter
Remove front curb, back splash plate and panel above the door.
Disconnect hotplate. On replacement, be careful to group terminal wires together
under spillage channel.
Hotplate switches. Switches are fitted to the left and right hand control panels.
It will be necessary to remove these panels for replacement.
Vulcan catering equipment (ptY)ltD
[ 11 ]
Ranges RE-3 and RE-3-T
REV3-11-2011 / VfM29