Power Connector Cable - HP 242 G2 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Hard drive (see
b. WLAN module (see
c. Solid-state drive (see
d. Memory module service cover (see
e. Optical drive (see
f. Keyboard (see
g. Top cover (see
h. Fan (see
i. System board (see
Remove the power connector cable:
1. Turn the system board upside down, with the front toward you.
2. Disconnect the power cable from the system board.
62 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
Hard drive on page
WLAN module on page
mSATA drive on page
Optical drive on page
Keyboard on page 46)
Top cover on page
Fan on page 56)
System board on page
33) and then remove the following components:
34)
37)
39)
Memory module on page
42)
49)
59)
Spare part number
732625-001
40)