Msata Drive - HP 242 G2 Maintenance And Service Manual

mSATA drive

Description
32-GB mSATA drive
Before removing the mSATA drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5. Remove the hard drive service cover (see
Remove the mSATA drive:
1. Remove the Phillips PM2.0×2.0 screw (1) that secures the mSATA drive to the system board. (The
mSATA drive tilts up.)
2. Remove the mSATA drive (2) by pulling the module away from the slot at an angle.
Reverse this procedure to install the mSATA drive.
Battery on page 33).
Hard drive on page
Spare part number
728857-001
34).
Component replacement procedures 39